1. Melting of fire prevention measures
(1) Fuel storage tanks and smelting plants shall be in accordance with the current Code of Fire Protection for Building Design. Keep the necessary fire clearance or separate with a firewall. (2) Oil storage tanks, oil pumps, pipes, valves and other fuel equipment must be carefully cleaned, degreased and ventilated to remove oil volatilization gas when it is needed for fire maintenance. It shall be inspected with a detector to ensure that there is no danger before moving fire. (3) When using the sawing method to dismantle the connected pipes or equipment, it is necessary to adopt the method of edge sawing to cut the edge when the construction is convenient. The company is located in:
2. Surface treatment of fire prevention measures
(1) The use of water pipes, the use of high-speed airflow and water surface impact aluminum flower box produced, flushing dust in the air stream, so that dust fall into the water pipe at any time in the pool. The company is located in:
(2) reduce the concentration of dust in the air duct to absorb heat in the air to improve the relative humidity in the air to achieve the dust, cooling, eliminate the source of the fire, excluding static electricity month. The company is located in:
(3) The air duct should always inspect the Anji aluminum box to remove the sewage and replenish the fresh water. The baffle under the water flap must be submerged under water for 200mm to keep the water volume and prevent the pipeline from clogging. Regularly clean the dust and fibers in the sedimentation tank. The company is located in:
(4) Without approval, there is no precautionary measures, all fire is strictly prohibited. The company is located in:
(5) The building should be spacious and high, the height should be more than 4m. Electrical equipment should be closed or explosion-proof, switches, etc. should be closed in a fixed switch box. The company is located in:
(6) Heating and ventilation of hot air blower and other equipment, the air flow should be roughly the same amount with the exhaust hood exhaust, so as not to accumulate aluminum dust on the heater. Polishing generated when polished ash to be cleared in time to prevent accumulation.